Thanks for purchasing our MPP.R Racing Bucket Seat Mount Kit for Tesla Model 3! This kit is relatively easy to install, but does require some parts from your OE seat. NOTE: The seat kit is only compatible with seats with a bolting face width between 384mm –...
Thank you for purchasing rear control arms for your Model S! Please read the instructions below carefully as these arms are not adjusted in the typical way. NOTE: It is CRITICAL that your alignment shop be aware of these instructions and understand how to adjust your...
NOTE: Torque-Spec for the E18 Caliper Bolts is 94nm/69lb-ft Installation Instructions: Time Required: 1 HourTools Required: 10mm Socket, E18 Torx Socket, Torque Wrench, Common Hand ToolsDifficulty Level: 2/10 Video: Check out this great video from our friend Chris...
Thanks for purchasing our compression rod inserts for the Model 3 and Model Y! These are easy to install, but make sure you have the orientation correct!NOTE: The inserts press from the top-down. Video: Check out this Installation Video from our friend Chris!...
Thanks for purchasing our sealed spherical front bearings for your Model S! These are easy to install with a press, but you will require an alignment after installation.NOTE: The wider bearing goes into the tension arm (the longer arm) Installation Instructions: Time...
If you’ve purchased our MPP.R Rear Subframe Inserts, we thank you supporting MPP as always! These inserts are super easy to install, follow the directions below and you’ll have no problem. NOTE: It is easiest to do one corner at a time, while leaving one...
