MPP Party Box And Cooling Party Controller Functional Overview

Party Box Activation

Activate the Party Box one of the following ways:

  • For Performance Vehicles, use Track Mode to turn the Party Box on and off.
  • For Non Performance Vehicles, press and hold the right steering wheel scroll wheel for 1 second to turn on, 3 seconds to turn off. If the vehicle is left in park for 10 minutes, the party box will turn itself off.

Note: Slip Start still works to activate the Party Box (this is a legacy feature). To turn off, first turn off slip start, then press and hold the right scroll wheel for 3 seconds.

The traction control indicator will blink repeatedly when the party box is enabled. 

Party Box Functional Overview (RWD)

When activated, all stability control functions will be deactivated. ABS will continue to work as normal. The party box will have a set traction control target that it will work to achieve. On the V1.0.0 that target is fixed at 30% slip + 10km/h. I.E. at 100km/h, the maximum allowed wheelspin will be 140km/h.

 

Party Box Functional Overview (AWD)

When activated, all stability control functions will be deactivated. ABS will continue to work as normal. The party box will reduce traction control intervention. If a significant amount of slip or sliding occurs, the car may detect this and trigger a warning, momentarily reduce power and then deactivate regen, and fully remove traction control. This occurance has been far reduced since Version 3 of our software.

For loose surfaces such as snow or dirt when more slip is needed, it is recommended to fault the stability control early (that is called HOON mode). To do so, hold the accelerator pedal to the floor for five seconds while in park.

Using the MPP Party Manager you are able to fine-tune the traction control settings to your desire, as well as set different pedal maps and torque bias maps for hoon mode.

 

Release Notes HERE

 

As always, keep the party box disconnected using the bypass connector whenever you’re not on the track. NEVER use the Party Box with Autopilot or when performing software updates. 

Cooling Party Controller Activation

Activate the Cooling Party Controller by holding the left scroll wheel for 1 second. Deactivate the Cooling Party Controller by holding the left scroll wheel for 3 seconds.
 

Cooling Party Controller Functional Overview

When activated, the controller will run the OEM Tesla cooling systems including the AC compressor, radiator fans and water pumps to remove as much heat from the system as possible. Once the battery gets to 20 degrees C, the AC compressor and radiator fans will run at a reduced rate, however the water pumps will continue to operate at 100% duty.

Version 3.05 launches our user-settable power limits and Push-To-Pass functionality. Using the MPP Party Manager software, you are able to set your desired power level at two different speed points, as well as your push to pass duration and power level.

Push To Pass can be activated with a short press of the left scroll wheel when the CPC is active, assuming the system has been enabled with the MPP Party Manager software. 
 

Release Notes HERE

 

Bookmark this page in your Tesla for fast viewing when needed.